Not to assume anything at this point. Reviewing differentials...other than obvious vertical fin. I went to Richard Crapp seeking printed/aka/engineered documentation for both. Will have to wait until there is more definitive Swallow line art. If an RCSB subscriber has DH 108 assembly drawings or photos it would be fabulous to compare to the wealth of Vampire documentation.
The issue is we do not have a comparitive point between Jack's Swallow and Vampire enough to make a judgement call whether a single mold bottom half could be created for both. The second mold top would accommodate the vertical fin if it were decided to include it in the mold so to clear the exhaust duct.
Arngeir, I apologize for not explaining myself clearly. We have not found the Jack Lynn Bale DH Vampire plan. The rear end of both plans require FSA compliance to the scale we decide to make both plans accommodate. This to decide to create a four or five piece mold for the two planes.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
![]](/skins/text/forum_images/header-bg.gif)
Portal Home
Forum Home
![]](/skins/text/forum_images/top-left.gif)
![]](/skins/text/forum_images/left-side-table-bg.gif)
![]](/skins/text/forum_images/right-side-table-bg.gif)
![]](/skins/text/forum_images/hide_min.gif)