Quote: Sparky Richard this got me thinking, I could get the tailwheel and hub all 3D printed in black plastic so even it it wears it will still be black.
Almost all my flying is on grass so it really shouldn't wear too much. It sounds like you mean the tailwheel wire is music wire wrapped in Ply to represent the aluminum fork?
My Hornet is 80" and i will use a Plastic robart retractable tailwheel for my gear.
I expect the allup weight to be around20# with electric motors.
I'm not familiar with styrodur does that need to be glassed and does it require extra reinforcement?
My elevator and rudder are foam cores sheeted with 1/16 balsa and glass.
Sparky
You probably can't do much better than a plastic Robart retract set. I have not made a tail retract set for a long time , I think I had one in my Mossie all those years ago.... The tyres can be good for a saving, some commercial ones are horrendous.
This bit in my Stampe thread , next 3 pages
The shaft and steering is Carbon but of coarse it dose not retract
3 D might work with about 1 % fill. I believe you can get some soft filament stuff.
PS, What is styrodur, Styrofoam?
|